316L elbow

The 316L elbow mainly contains Cr, Ni and Mo, and the corresponding label is 022Cr17Ni12Mo2. The number represents the percentage after taking the middle value

316L elbow is a common pipe type in pipe structure, which is very common in pipe diversion connection. Separate the elbow area according to the visual angle (usually 30 ° stainless steel elbow, 45 ° stainless steel elbow, 60 °, 90 ° 180 °)

Before installing the 316L elbow, make sure that all sides of the 316L elbow meet the requirements for use. Clean the surface of the stainless steel elbow for all defects caused during careful service and transportation. When you are ready, you can install it

Please install the stainless steel elbow directly in the pipeline by connecting according to the use place. During installation, it is important to confirm the air tightness and avoid leakage. Otherwise, the normal operation of the pipeline will be affected. To prevent stem movement and leakage, it is necessary to tighten the valve packing bolts on the stainless steel elbow to avoid deflection. When using the valve, do not use it to adjust the flow to prevent corrosion of the sealing surface

316L elbow shall be checked in time. Usually open to the outside of the manufacturing and machined surfaces. It should be cleaned to remove dirt and kept clean in a well ventilated room. Stacking and outdoor storage are prohibited. 316L stainless steel elbows are usually kept dry, ventilated, and stored in the correct way